Using a mouthguard in contact sports is very important, especially for junior players. A properly fitted mouthguard is essential for you to be protected. The most popular types of mouthguard is the mouth formed or boil and bite which is heated and then formed to fit your mouth.
Moulding a mouthguard is made easy using our directions. Firstly, boil a small pot of water and submerge the mouthguard for about 20 to 30 seconds. Your mouthguard should have instructions for the correct amount of time. Remember, the mouthguard should be heated to the point that you are able to mould it not the point where it is beginning to melt.
Remove the mouthguard from the water using tongs as you do not want to deform the mouthguard by squeezing too tightly. Cool the mouthguard either by dipping it in cool water or allowing it to air dry. Check your mouthguard instructions to see if water is recommended. You only need to cool the mouthguard to the point where you can put it in your mouth without burning yourself.
Place the mouthguard in your mouth to mould it. Push the mouthguard against your teeth with your fingers and bite down lightly. Pull the guard tighter to your teeth by placing your tongue against the roof of your mouth and sucking the air and water out.
Now you need to cool the mouthguard. Some instructions say that the guard needs to cool rapidly after it has been fitted by dipping it in cold water. If the mouthguard does not fit properly, you can remould it by starting the process again.
Using a mouth formed mouthguard is the easiest way to ensure the mouthguard fits perfectly to your mouth. Be sure to inspect your mouthguard frequently and replace it if it becomes deformed or you notice that the edges become jagged.